My microwave handle broke last week, and I was faced with the daunting task of replacing it. I had never attempted any kind of appliance repair before, so I wasn’t sure where to start. After doing some research, I found that replacing the handle on a KitchenAid microwave is actually a fairly straightforward process. In this step-by-step guide, I will walk you through the process of replacing the handle on your KitchenAid microwave.
Gather Your Tools
Before you begin the process, it’s important to gather all the necessary tools. Here’s what you’ll need:
– Screwdriver:
A Phillips or flathead screwdriver depending on the type of screws used on your microwave handle.
– Replacement Handle:
You can purchase a replacement handle from the manufacturer or from a third-party seller.
Remove the Old Handle
Step 1: Unplug the Microwave
The first step is to unplug the microwave from the power source. This is a safety precaution that should not be skipped.
Step 2: Open the Microwave Door
Next, open the microwave door and locate the screws that hold the handle in place. Depending on the model of your microwave, you may need to remove a plastic cover to access the screws.
Step 3: Remove the Screws
Using your screwdriver, carefully remove the screws that hold the handle in place. Be sure to keep track of the screws as you will need them to install the new handle.
Step 4: Remove the Old Handle
Once the screws are removed, gently pull the old handle away from the microwave door. Be careful not to force it as you may break any remaining pieces.
Install the New Handle
Step 5: Attach the New Handle
Take the new handle and align it with the holes on the microwave door. Carefully insert the screws into the holes and tighten them with your screwdriver. Again, be careful not to overtighten as this may cause damage.
Step 6: Test the New Handle
Once the new handle is securely attached, give it a gentle tug to ensure that it is properly installed. Close the microwave door and open it a few times to make sure the handle does not wiggle or come loose.
Step 7: Plug the Microwave Back In
Finally, plug the microwave back into the power source and test it to make sure everything is working properly. If the microwave turns on and the new handle feels sturdy, then congratulations, you have successfully replaced the handle on your KitchenAid microwave!
Conclusion
Replacing the handle on your KitchenAid microwave may seem like a daunting task at first, but with a little patience and the right tools, it can be done. Follow this step-by-step guide and you’ll have your microwave looking good as new in no time. Remember to always prioritize safety and take your time during the process. Good luck!